How to Setup Netgear R9000 Router

By | February 19, 2018

When, We are going to configure Netgear R9000 router , first of all turn on your nighthawk router , once the power light is solid white, connect Ethernet cable from yellow internet slot of router to your cable modem or DSL modem, then connect extra Ethernet cable from Port2 of nighthawk router to your computer.

Once you are done with the cables , You need to make sure that the cables are connected properly. Then restart your modem & nighthawk router, Than after 40 seconds you need to turn on the modem, router,

 Then all the lights will be stable on the router & modem. Open your browser on your computer and type routerlogin.net or routerlogin.com in address bar on the browser, genie configuration page will come up, click on the first option (Yes, I want net-gear genie to configure my router) Now wait for a movement you will get a next option, to set up router in access point or router mode, Select any option which suits you to finish the net-gear genie setup process

Netgear R9000 Router Setup

Process for Troubleshooting Netgear R9000 Router

Try to restart your router, wait for all the signal lights to turn green or white, In case of new AC series of routers lights will turn solid white. Please make sure that your device is also connected to wireless or wired mode with router or modem. Now, check the IP address (Default gateway or default IP address of any net-gear router is 192.168.1.1, Where in some cases it can be 10.0.0.1. )

When, We have DSL & cable modems try 192.168.0.1 Try to resetting the router using a paper pin or clip for 10 seconds & then you need to try routerlogin.net or routerlogin.com

Searchable Queries : netgear router configuration, netgear routerlogin access, netgear routerlogin page, netgear routerlogin net admin page, how to setup new netgear R9000 router, toubleshoot netgear router

Leave a Reply

Your email address will not be published. Required fields are marked *